Performing a Factory Restore on the Polycom EagleEye Director

If the Polycom EagleEye Director is not functioning correctly or you need to
recover from a corrupted partition, you can use the restore button to reset the
device. This operation completely erases the camera’s settings and reinstalls
the software.

The following figure shows you the location of the restore button on the back
of the Polycom EagleEye Director.

To reset the Polycom EagleEye Director using the restore button:

1.  Press and hold the restore button on the back of the EagleEye Director for2-3 seconds while the  power light cycles. When normal video content is displayed on the monitor instead of a blue screen, the EagleEye Director has been successfully restored.

     2.  Release the restore button.